VBA + Xbox 360 Controller

windraven · July 14th, 2011, 04:27

Heyo,

I assume I'm not the only one using VBA and a XB360GC, but I wanted to know if others were having this issue.

I plug it in, configure it, and it all works correctly. Except, when I set up the joysticks for the up,down,left,right controls, I can only move one of those directions at at time. I can't go diagonally.

This is annoying, as some of my favorite games are the Zelda games, where moving diagonally is rather useful (and obviously, this limitation doesn't exist on my gameboy proper).

Anyone else have this issue / know what I might be doing wrong?

Thanks so much.

July 14th, 2011, 04:27	#1
windraven Registered User Join Date: Jul 2011 Posts: 2	VBA + Xbox 360 Controller Heyo, I assume I'm not the only one using VBA and a XB360GC, but I wanted to know if others were having this issue. I plug it in, configure it, and it all works correctly. Except, when I set up the joysticks for the up,down,left,right controls, I can only move one of those directions at at time. I can't go diagonally. This is annoying, as some of my favorite games are the Zelda games, where moving diagonally is rather useful (and obviously, this limitation doesn't exist on my gameboy proper). Anyone else have this issue / know what I might be doing wrong? Thanks so much.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode