Problem running ISOs

[lordneeko]

Epsxe runs great when I run CDs. Except sometimes the movies are a little choppy. So I thought I would try putting a few of my games on ISO to speed up movies. However, I got it imaged and when I run it nothing happens. I've tried the ISO plugin to see if that would fix it but it didn't. Does anyone know what I'm doing wrong? I created the image with CDRWIN if that means anything. And it's an ISO9660 file. So I don't know what's wrong. Anyone?

[liquid]

You can also try using ISOBUSTER which can be downloaded from www.aldostools.com (http://www.aldostools.com) I've used this and CDRWIN without any problems. BTW I find ISOBUSTER to be a little more intuitive to use in comparison. Just be sure to name the file with a .ISO extention.

If you do a search for ISOBUSTER in the screenshot section you will find graphical instructions posted by one of the regulars (it was about a month ago so I don't know if it's still there).

[ToM_E]

I found ePSXe running iso have problems. When I run it and then close it and then run it again it says illegal operation and shuts down by itself...

[lordneeko]

Well, I get everything imaged and stuff with CDRWIN and I compare the CD to the Image and it's exact. When I load it in EPSXE It goes through all the steps and the screen goes to full screen, and nothing loads.

[fivefeet8]

I use cdrwin to make isos too and I have been able to make perfectly playable iso's of my games so far.. This is my config of cdrwin.. Try using these options..

[lordneeko]

Thanks that's worked